blending problems

[theXbucket]

hey,

I try to blend car fender, but I don´t know, why this doesn´t work - well - on the front fender it worked without problem. you can see this in the picture and in the file.
why does it work on the front but does not on the back? :-o
thanks in advance!

Greetz xBucket

[EquiNOX]

Why don't you..... (See attachment)

1. Create arch surface

2. Trim It

3. Blend surface between Rear and Front Arches

See if it works for you.

Hope that helps.

[theXbucket]

hi! i got a clean shape than, but i loose control about where the red line is. so if i´d like to get a straight red line from the top view this doesn´t wokr, or am i too confused?

thanks EquiNOX

greetz

[74j4]

You have uneven curvature flow in your arch surfaces. You need to balance them out before any blend between them blends evenly.

[theXbucket]

hm... i adjusted the curves but still not that great.... :-/ what am i missing?

greetz and thanks so far!
xBucket