Gizmo-200sx

[.GizmO.]

In this topic im going to show my progress of my Nissan 200sx.

Here is my first wip.

I've done a bit of the hood and now going to model the front bumper.

I hope I can help people and that people can help me.

Regards,

Gizmo

[TwoOneOne]

if you want to help you should:

• show some close ups of tricky stuff (seams, corners)
• show more pictures...taken in shorter intervals so people can see your workflow.
• write some explanations how you achieved your result.

[mechatronz]

Amen ! :buttrock:

[.GizmO.]

if you want to help you should:

• show some close ups of tricky stuff (seams, corners)
• show more pictures...taken in shorter intervals so people can see your workflow.
• write some explanations how you achieved your result.

Thanks for the explaining.
I'm going to do it right now.

I've attached my first problem.
I've got 2 exact same corners, but one is sharper than the other, how can I fix that?
I want to have them both sharp.

[TwoOneOne]

both corners should look like this:



to achieve this do the following:


1. insert edge


2. insert edge


3. insert edge


4. bevel edges (here you can actually also use extrude to get three edges...or if your app has round bevels, set the roundness to 1)


5. apply meshsmooth



hope that helps all participants to understand things better.

[Hitmen]

TwoOneOne cool! O_O Now i know how to make perfect corner

[marbl]

Thanks 211! Its very useful! :buttrock: But teel me how to insert thouse edges? With cut? or chamfer?

[.GizmO.]

Thanks, I tried it and it looked great, I'll post my wip's when I've done all corners.

Thanks 211

[TwoOneOne]

Thanks 211! Its very useful! :buttrock: But teel me how to insert thouse edges? With cut? or chamfer?

in max you can use the "connect" tool. use the slide value to adjust the position of the edge.

[.GizmO.]

Here my car wip 211's corners.